Tell us what you need: your sheets, trims and accessories. We'll review it and send you a quote. Not sure about something? Add it to the notes and we'll call you.
Choose a profile and colour, then list each quantity and length below it. Need a different profile or colour too? Click + Add another profile / colour.
Tip: you can type the whole length in inches (e.g. 120) and it changes to feet and inches for you. Press Enter to jump to a new line.
These open in a new tab, so you won't lose anything you've entered here.
This is an estimate only. We'll double-check your numbers before quoting.
Choose a colour, then list each trim and how many pieces you need. Need trim in another colour? Click + Add another colour. See our trim page for pictures. Need a custom trim? Click Draw a custom trim and sketch it. We'll get every side length and bend angle.
Click or tap to set the start point, then click at each bend. The green dot shows where your next line will start. Use Toggle starting point to move it to the other end (to add a flange there). Lines snap to 5° angles and 1/8" lengths. You can type exact lengths and angles in the table too. The yellow dotted line is the painted (colour) side.
| # | Length | Angle ° |
|---|
Angle on side 1 is the start direction. On every other side it's the bend from the side before it (+ = bend clockwise, − = counter-clockwise).
